I looked around and could not find anything. I just upgraded to x7 Mastercam. I found a post online for Mach3 on Mastercam. But the post makes the machine move back to 0,0,0 after spindle turns off every time. I either need a different post or figure out how to modify this post. I opened it on notepad and it says at the start:

# Additionally, this Post homeS the tool to 0,0,0 Note this Post raiseS Z an absolute distance of 0" above the work surface.
# This returns the tool to the reference point in Mach3.

I read thru most of the post and it understand some of it but a lot of it is weird. Any ideas?

Thanks Eric,