[DJ Morrow]

I could sure use a little help assembling a power supply.

I have a couple of 24V, 10A LP-520 transformers, a 26,000uF capacitor and a bridge rectifier. I'd like to wire it all up to power my Gecko G201's and MGC 258 oz steppers. In bipolar parallel, the steppers are rated at 2.31 V and 4.20 amps.

Rather than trying to describe all the colors and numbers, I made up a small diagram. You'll see that I have arbitrarily supplied numbers to the wires on the transformers. So, hopefully, someone can tell me to connect wire #xxx to #yyy etc and when all is done, the smoke stays inside the parts.

http://www.ldrider.ca/CNC/powersupply.htm

Feel free to offer advice on whether my parts are properly matched, Series vs parallel, etc.

Looking forward to being enlightened.

Thanks everyone

[widgitmaster]

http://www.mcitransformer.com/i_notes.html
http://www.bright.net/~agarb/STMD/Power%20Supply.html
Hope this helps!
Eric A.A.