The CHNC 4's controller runs on single phase 120. I have three wires running to the controller: red (hot); white (neutral); and, green/yellow (ground).
The attached pic shows possible connection points, which are labelled U V and W, but UVW are normally labels for three phase power.
Can anyone help me to connect this properly? Thank you!
Attachment 200920
Results 1 to 3 of 3
-
09-15-2013, 12:40 PM #1
Registered
- Join Date
- Sep 2013
- Posts
- 1
Power wires for CHNC 4 controller
-
09-15-2013, 02:28 PM #2
Registered
- Join Date
- Feb 2004
- Posts
- 71
Mine is wired with the red on the left, the white in the middle, and nothing on the right.
The green wire is ground, and is wired to a ground terminal about a foot above these terminals.
My CHNC4 has the Fanuc 6TB control too.
Royce Bunnell
Pool Cues | Billiards and Pool Cues | OB Cues
-
09-15-2013, 04:32 PM #3
Registered
- Join Date
- Sep 2013
- Posts
- 1
Excellent. Up and running. Thank you!
Reply With QuoteSimilar Threads
-
6 Wire Motor-4 wires to controller
By Gallchobhair in forum Stepper Motors / DrivesReplies: 2Last Post: 09-14-2012, 04:08 PM -
CHNC 4 With GN6 Controller won't power, HELP
By Rick L in forum CNC (Mill / Lathe) Control Software (NC)Replies: 0Last Post: 09-26-2011, 06:07 AM -
Power up for CHNC II
By jabernowl in forum Hardinge LathesReplies: 1Last Post: 09-15-2010, 03:46 PM -
Problems with proximity of AC power & stepper wires?
By jhowelb in forum CNC Machine Related ElectronicsReplies: 12Last Post: 12-17-2008, 04:28 AM -
What is the 3 wires at the back of the X2 power unit for?
By alexccmeister in forum Benchtop MachinesReplies: 3Last Post: 06-27-2007, 02:51 PM
Posting Permissions
