I am using a linear slide for my "Z" that has a 3/16" shaft. Then I am using a stepper w/ a 1/2" shaft in direct drive. I need to connect these two w/ a coupling and am not having any luck finding this combo. Tried MSC - Enco no luck - any suggestions folks??
Bill
Results 1 to 5 of 5
-
10-10-2008, 01:12 AM #1
Registered
- Join Date
- Nov 2007
- Posts
- 343
Shaft coupling supplier needed - help!
-
10-10-2008, 02:59 AM #2
Registered
- Join Date
- Dec 2007
- Posts
- 52
I would try brent hubbard he has an e-bay store I think it is hubbard cnc. or mcmaster carr they carry almost anything you can dream of
-
10-10-2008, 06:11 AM #3
Registered
- Join Date
- Feb 2006
- Posts
- 133
Bill, The boys at Applied Industrial in Olympia can fix you up I'm sure...... Tell Kenny I sent you over and he can find anything you need.
I'll second the McMaster Carr site, I really think they have everything imaginable!
Steve
-
10-15-2008, 04:48 AM #4
*Registered User*
- Join Date
- Mar 2006
- Posts
- 4
McMaster - or with this being fairly small shaft you may try SSDCP
-
10-15-2008, 10:48 PM #5
Registered
- Join Date
- Nov 2007
- Posts
- 343
Thanks guys - found one.
Reply With QuoteSimilar Threads
-
Looking for a Coupling for 1/2" motor shaft to KR33 6mm shaft
By DonW in forum DIY CNC Router Table MachinesReplies: 7Last Post: 03-17-2008, 09:58 PM -
Thinnest insulation foam (XPS) supplier needed
By salvaCNC in forum CNC Wire Foam Cutter MachinesReplies: 0Last Post: 02-04-2008, 06:00 AM -
Greenhorn question...supplier needed
By Kozmonyet in forum Stepper Motors / DrivesReplies: 3Last Post: 10-25-2007, 06:58 AM -
Looking for a supplier of interior splined shaft
By JerryFlyGuy in forum Mechanical Calculations/Engineering DesignReplies: 2Last Post: 06-09-2006, 08:29 PM -
Small hose clamps - screw to shaft coupling?
By Chris D in forum Mechanical Calculations/Engineering DesignReplies: 5Last Post: 03-20-2006, 07:50 PM
Posting Permissions
