hello fellow CNCers I am new to cnc , I have a cnc router that runs vectric and Mach 3 and it works great and i get it , now i have 2 older cnc spectralight lathes with control boxs and no software , I have acquired a control board with a power supply and a card for my computer but I have not put it all together yet ( i am very mechanically inclined, but not computer savy) I also need a cad program for turning so I can create or scan in a design , set my perameters and send it to Mach3 the same way I do with vectric, I could also use help assembling my controller, I have also considered getting a new sherline cnc lathe and using the controller and computer that comes with it to run the old lathes , one at a time with a switch-box of some kind. I have one that splits 2 , I am sure that there is one that splits 3 ....so thats most of my story, lots of hardware and lots of stuck,,,,, any and all help wanted