[NSSJREng]

I’ve got an Intermac 33 CNC where the a axis has travelled way past where it should, the fault codes on screen say that it has activated both the hardware up and down limits, which it hasn’t only one of the plungers on the limit switch is active, which is the front most one due to its position and the flags that activate the limit, and also “software end of range UP”. It is physically tilted pretty much 45 degrees anti clockwise from home. I need to know how to get it to drive back to being straight, which it won’t manually. And then how to calibrate the axis. Any help thank you

[NSSJREng]

The following fault codes appear on screen;
AXS 629- Axis at the UP hardware limit switch. Axis A
AXS 630 - Axis at the DOWN hardware limit switch. Axis A
AXS 336 - Axis at software end of range UP. Axis A

[lixiaoyu]

Dear NSSJRENG!
How are you. I am nick. come from china. I am service engineer. befor work for intermac company. If you have any question about intermac master cnc and Genius CT . let me know . Maybe I can help you. my whatsapp ID +86 13585355877 my email adress : [email protected]. Hope a good info for you.