603,882 active members*
5,110 visitors online*
Register for free
Login

Thread: G74 peck cycle

Results 1 to 2 of 2
  1. 09-23-2010, 08:10 PM #1
    hmc710
    hmc710 is offline Registered
    Join Date
    Jul 2005
    Posts
    179

    G74 peck cycle

    Doing a peck drilling cycle on Tornado 200 using G74 code. Example in book is metrid and shows a peck distance for 5mm is entered as Q5000 and 10mm is Q10000, because of leading zero suppression. What would .10" be entered as, it doesn't like decimal points and I don't want to crash.
    Thanks,
    H
    Reply With Quote Reply With Quote
  2. 10-08-2010, 02:49 PM #2
    graham35
    graham35 is offline Registered
    Join Date
    Oct 2010
    Posts
    0
    That value is in microns

    5000 = 5mm

    .10" = 2.54mm = 2540 microns
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Peck Drill Cycle G83
    By Sam A in forum G-Code Programing
    Replies: 24
    Last Post: 02-20-2016, 06:30 PM
  2. G83 Reduced Peck Cycle
    By leeputman in forum Mastercam
    Replies: 1
    Last Post: 04-07-2010, 11:21 PM
  3. G83 using I,J,K for Reduced Peck Cycle
    By leeputman in forum Haas Mills
    Replies: 2
    Last Post: 04-07-2010, 08:04 PM
  4. peck drilling cycle
    By saravananraju76 in forum Hyundai Kia
    Replies: 1
    Last Post: 11-26-2009, 02:11 AM
  5. fanuc -om peck cycle
    By PETE1968 in forum Fanuc
    Replies: 4
    Last Post: 04-06-2006, 03:57 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules