603,942 active members*
4,696 visitors online*
Register for free
Login
IndustryArena Forum > MetalWorking Machines > Daewoo/Doosan > Doosan 2000Sy Ploygon turn????

Thread: Doosan 2000Sy Ploygon turn????

Results 1 to 3 of 3
  1. 09-29-2010, 05:10 AM #1
    mroy0404
    mroy0404 is offline Registered
    Join Date
    Aug 2004
    Posts
    218

    Doosan 2000Sy Ploygon turn????

    Hello guys


    I have a 2006 Doosan 2000SY with Fanuc 18i-TB, I have an on going job(4140HT) that requires a .970 OD turned about 1.5" long then a .875 Hex milled for about .5 long with an exit rad at bottom edge of hex. Been doing this so far using X,Y axis & live tool doing 2 passes, this takes about 1 min. Far to long for my likings!!!
    I have watched afew youtube vids about Ploygon turning, any of you guys done this before??? where can I buy a polygon live tool?

    Mike
    Reply With Quote Reply With Quote
  2. 10-06-2010, 08:45 PM #2
    phx
    phx is offline
    Join Date
    Feb 2003
    Posts
    349
    Other Applications ~ Horn USA, Inc.

    you know you need the Option Polyturning?
    Reply With Quote Reply With Quote
  3. 10-12-2010, 06:54 AM #3
    MysticMonkey
    MysticMonkey is offline Registered
    Join Date
    Mar 2009
    Posts
    379
    Can you not polar coordinate interpolate with C & X ?

    I assume your Lathe had Ez-Guide on it

    I'm not a programmer so I can't go into the specifics.
    ************************************************** *********
    *~~Darwinian Man, though well-behaved, At best is only a monkey shaved!~~*
    ************************************************** *********
    *__________If you feel inclined to pay for the support you receive__________*
    *_______Please give to charity https://www.oxfam.org.au/get-involved/_______*
    ************************************************** *********
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. B Axis Control for 2000SY
    By Daewoosan in forum Daewoo/Doosan
    Replies: 1
    Last Post: 01-09-2011, 09:06 PM
  2. Pls. Help Thread Milling on a Doosan 2000sy
    By mroy0404 in forum G-Code Programing
    Replies: 6
    Last Post: 03-27-2010, 06:30 PM
  3. 2000SY
    By STS_Kevin in forum Daewoo/Doosan
    Replies: 7
    Last Post: 02-01-2010, 07:00 AM
  4. 2006 Doosan 2000sy Fanuc 18i-TB
    By mroy0404 in forum Daewoo/Doosan
    Replies: 4
    Last Post: 01-30-2010, 03:40 AM
  5. 2000SY Centre
    By JHECNC in forum Daewoo/Doosan
    Replies: 3
    Last Post: 10-03-2009, 07:03 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules