603,923 active members*
3,368 visitors online*
Register for free
Login

Thread: horizontal and vertical control

Results 1 to 4 of 4
  1. 05-16-2011, 03:18 PM #1
    makenparts
    makenparts is offline Registered
    Join Date
    May 2011
    Posts
    0

    horizontal and vertical control

    Hi everyone, first time doing this on the site, we have a bridgeport eztrak II our monitor went out so we replaced it and now the screen is in the lower right corner how do we adjust the horizontal and vertical hold control
    Reply With Quote Reply With Quote
  2. 05-17-2011, 01:40 PM #2
    machintek
    machintek is offline Moderator
    Join Date
    Nov 2004
    Posts
    3028
    Sounds more like you have a newer HD monitor that is being fed a VGA signal.
    Try changing the display on the monitor set up.

    George
    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
    Reply With Quote Reply With Quote
  3. 05-17-2011, 02:18 PM #3
    makenparts
    makenparts is offline Registered
    Join Date
    May 2011
    Posts
    0
    how do you get to the monitor set-up in the system and the numbers on the screen that tell you what buttons to push do not show up on the screen thanks again
    Reply With Quote Reply With Quote
  4. 05-18-2011, 12:49 AM #4
    machintek
    machintek is offline Moderator
    Join Date
    Nov 2004
    Posts
    3028
    You need the book on the monitor.
    There is not much you can do on the machine motherboard end unless you have a new modern mother board. And then You would have to consult that manual.

    George
    (Note: The opinions expressed in this post are my own and are not necessarily those of CNCzone and its management)
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. CNC Machining Center- both Vertical and Horizontal - MI
    By MachiningJobs in forum Employment Opportunity
    Replies: 0
    Last Post: 04-04-2011, 10:49 PM
  2. carusel horizontal o vertical
    By matriceria_fae in forum Spanish
    Replies: 1
    Last Post: 08-08-2010, 02:30 PM
  3. Horizontal / vertical mill How to post ?
    By vsengineering in forum Mastercam
    Replies: 2
    Last Post: 07-27-2010, 08:48 AM
  4. kempsmith #4 mill (horizontal/vertical )
    By Goldhunter_2 in forum Uncategorised MetalWorking Machines
    Replies: 2
    Last Post: 11-19-2009, 10:08 PM
  5. Vertical/Horizontal Bandsaw purchase
    By ChrisJ in forum MetalWork Discussion
    Replies: 3
    Last Post: 07-21-2007, 02:30 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules