Greetings all!
I'm attempting to help a good friend of mine out who's working through some hard times...
He's got a 1994 Haas VF-0, 3-phase, 5HP. When the machine boots up, it immediately displays a "149 - Spindle Error"
The VFD is a Magnetek GPD503-DS307, it has the proper power going in, but no display or output.
I've pulled it from the machine, and after removing the top board, see that there are burned traces around a large FET (Think it's a FET)
and heatsink. We're looking at getting it repaired, but also considering replacing it. He's on a pretty tight budget, trying to get back on
his feet after a major setback last year. I'm helping him however I can.
I'm learning that there are some very specific parameters that need to be programmed into the VFD for use in the VF-0.
What I'm trying to find out, without having to replace any other components, are there any other VFD's out there, that will accept the Haas setting/parameters, and be an acceptable replacement for the GPD503-DS307?
Any thoughts and opinions are welcome. The leaning right now, if a good friend of mine who used to do board repair can't fix it, we'll go ahead and send it into to a service center and have them refurbish it. Just looking for replacement options.
Just in case anyone else runs into this AND knows someone willing to tackle board repair, that Toshiba IC that's very difficult to read is a GT50J101!
Thanks VERY much!!
Ron