Hey all, my machine doesnt seem to know where it is and hits the side and makes an awful noise. How do I set up / caliberable the bed so the machine knows where it is? Im using GRBL for laser software
Hey all, my machine doesnt seem to know where it is and hits the side and makes an awful noise. How do I set up / caliberable the bed so the machine knows where it is? Im using GRBL for laser software
Do you have home switches/sensors?
Which G-code sender are you using (GRBL is just a software that resides in arduino).
Make no mistake between my personality and my attitude.
My personality is who I am. My attitude depends on who you are.
thanks for the reply. I am not using switches/sensors and I am using Lightburn to send to the machine. Really keen to try and get this figured out so I can start using the machine and also then try and tackle the router part!
Thanks again
https://www.acestardigital.com/Acestar is a 360° creative digital marketing agency & company in Navi Mumbai giving services like SEO, SMM, PPC, Web Design, ORM, Digital PR
Obviously LightBurn does not know where your laser head is.
I do nit use LB but there are a lot of videos on YT showing how to set LB to work with any machine.
You should not use Homing routine if you do not have home switches installed.
I guess that there should be an option to strat your job from actual position.
Make no mistake between my personality and my attitude.
My personality is who I am. My attitude depends on who you are.