[jimcisme]

Hi,
I bought a 1400-5 control and the machine originally had a 1400-2 control. The questions below were not in the SET-P for the -2 control so I’m kind of lost.
A few of these state what the standard setting is but any information about the settings would be great as I have no reference to go by for how they work or what changes I might make.
My machine is a 1990 4020 with the 21 station turret. No servo. Questions as follows.

1. Turret Factor?
2. Aspect ratio of Y to X ?
3. Motor overload factor?
4. Max rapid ? (I have new turcite on all the ways and all new oil lines and metering valves. I have read that the older machines are 400 IPM but the math works out to 720 IPM being possible.)
5. XYZ ramp?
6. Air valve feedback?

Regards,
Jim

[machinehop5]

...this may help with some of the settings and what they do in more detail.
https://flintmachine.com/images/uplo...Parameters.pdf

[jimcisme]

Thanks, I obviously need to look at the manuals a little closer. I have that manual but never saw that. It's just what I needed though. Thanks again.

Sent from my SM-A326U using Tapatalk