Hi there
I Program a Maz Intergrex 400 iv with sub spindle.
Whilst performing synchronise turning with spindle 1 as master, I continually have issue's with 'W' axis over loading.
I have tried multiple ways to avoid this even using a live centre held in spindle 2 chuck.
Have noticed burn/harmonic marks on chucking diameters from jaws also.
'W' Axis seems to load up while machine and even stationary.
I have also noticed slight differences in the servo monitors Droop/Gain between the two spindles while machining.
If any one else has had a similar problem and knows of a remedy it would be greatly appreciated
Aaron