Hey guys. I'm having an annoying problem during a simple tool change. At the "T2 M6" line, I insert the tool into the spindle and press "cycle start". This causes the Z to slowly extend all the way down and crash the tool into my work. Mach does not seem to move beyond the "T2 M6" line. The spindle never starts or anything. I end up hitting reset but I'm assuming the Z would continue to go until it hits limits. Any ideas? Thanks in advance
(2D CONTOUR1)
M5
M9
M1
T2 M6
S6300 M3
M9
G0 X1.8256 Y-1.7295