First time here. just picked up a 24x48 horizon engraver made by Vision engravers about 1995. There is a computer & controller with the machine. Coming off the engaving table is a 4 prong plug with 3 pin, I believe this is power to the spindle motor but cant find a power supply to hook it up to? Anyone using a Horizon or older Vision engraver? Looking for any info on table and controller(soft ware that was used with controller?)?
Vision engraving has little info, they will sell new controller for 5895.00. If I cant revive the old I will have to look for used or make my own. Looked at ghina controllers but dont now?
thanks dennis