I ran a 2/3 full nested 1/2" particleboard sheet with a 1/4 compression bit. I took everything nice and easy with precaution as in good spirits I wanted have a full success. Feed rate was at 225 and took about 30min to cut. I also had both stages on the vacuum turned on. I added a final depth pass to the gcode (onion skin) at about 0.02. I'll probably reduce it to 0.01 once I tram better, as I'm getting the common lip issue. The onion skin is pretty important when cutting a nested sheet like this. Do keep in mind you want to select smallest cut vectors first.

Attachment 262360




I still didn't install a vacuum gauge so im not sure how much in/hg im pulling. However, I'm very happy with the way things are turning out, it works great!

Things to do
- Tram again (haven't really spent time on it)
- Auto Zero plate and touch off tools change plate
- cyclone for the dust collector

Thanks everyone, stay tuned!