I have an issue. The computer controlling my router died. It was old and had a parallel port. The new one does not have a port and running windows 8 64 bit I had to get a smooth stepper. After connecting and following the instructions from Warp9, two of the three axis' work, but X does not. I've done some troubleshooting by swapping motors around on the gecko and the X motor work when it's on Z. Since it's controlling the other axis okay I'm leaning towards an issue with the settings in Mach3 or the settings for Smooth Stepper. When I tell Mach3 to move X I see the numbers moving on Mach3 but the X axis does nothing. Also Jog is not available Any help would be appreciated.