Recently and it seems rather suddenly that machined parts are substantially out of dimension.

The machine has little machining time on it, in the hundreds of hours.

I did a quick test by putting a .0001 dial on the spindle the X and Y and putting maybe 40 pounds push on the table, this deflects the needle by more then .0015.
I presume cutting forces would push it past that. This was done with the bed more or less centered where most all machining has been done.

The table was also checked at extreme ends of Y where essentially no machining has been done with mostly similar backlash readings.
Did not check X before having to leave at that point.

Looking for some advice/suggestions on what to look for and/or what to do next.
Am wanting to do what I can for obvious reasons before calling Haas to diagnose the issue.

Thanks much
Ken