Hi!
I really need for your helps about Ladder Fanuc!
I want to download Ladder of Fanuc 15M to PC by Fanuc Ladder III, but I have some problem :
- I connected and set up the communication of FAPT III
. Setting Port = Com 3
. Baudrate = 4800 ( The same PMC I/O)
. Parity = Even
. Stop bit = 2
- Set Keep relay K17.1 = 1 (01000110)
- Select PCPRM - I/O - Channel I/O = 0 (cannot change)
- Select Output - P-G (FAPT Ladder) - Execute
- In the FAPT,
. Tool - load from PMC - I/O by monit online - Connect and wait a few seconds the FAPT alarm disconnect.
. When I select I/O by "I/O" key operation - ladder - Finish ( I see the monitor of CNC machine notices output complete but The FAPT software still executing and nothing happens. When i cancel, the FAPT notices " MCARD file not found ".