[roguedog]

Just picked up a axyz 4008, 1999 vintage. It ran when disconnected, I am aware of the toolpath/controller limitations nd plan to retrofit with something newer.

Looking at the control box, it was setup for 3 phase but looks to be able to run with 220v single phase also. To do the switch, is it as easy and just hooking up to the 2 breakers shown in the picture where is shows '220-1ph'? I do not have a manual for the machine with any wiring diagram, so I am not sure if anything else needs to be switched for running on single phase?

Thanks for any info.

Attachment 506348

Attachment 506350