Has anybody got any advice for me i have been using key cutters to start with and didnt have any luck.i know there is no geometry in a cutter like that but that was how they did it before i started working there.So what i wanted was a
staggered tooth milling cutter but it would have to be cut down,because i need
.102 and i can only get .094.So instead i got a metal slitting saw with side clearance which has carbide teeth on both sides,But it still sticks to the material around the cutters teeth.Cutting a piece of plastic shouldnt be this hard to
work with,I tried different speeds and about 300 rpms it didnt work to bad but still melts the material a little.the best way i found to do these parts was to run them on the circular saw,which runs 3 times faster than the bridgeport i using the slitting saw on.so would you think that a staggered tooth cutter would work better than a side chip clearance cutter?Anybodys experience on this matter would make my life a lot easier.thank you