Hello everyone. I have recently purchased a Bridgeport Series 1 with a TNC151 control. I have never used this type of machine before. I was wondering which method most people prefer to run their programs. Can this machine be run directly from a computer that is running mastercam X? If not what is the next best method? Would I convert my mastercam drawing into g-code and load it in with TNCremo? Or how about the TNC151 conversational programing? While reading the forums people are saying that the manual can be found on their website but I have looked and can't locate it. I did find the TNCremo software but I can't find the TNC151 control manual. Thanks for any help.