Hi. Hope this isn't too whacked of an idea for my first post, but here goes.

I just saw on e-bay for sale, a RUNNING P/W R4360 Wasp Major radial engine,(http://cgi.ebay.com/ebaymotors/ws/eB...m=380002382354) and thought to myself, "But what the heak could I ever use it for?". It's just way out of my league, but for under 6 grand, I nearly fell over. That got me thinking to something smaller and more usefull, maybe, a lawnmower engine? Something affordable and useable, even if not very practical... ok. how to go about it. I wish to be a little honest here. I have a 10th grade education, and about 2 weeks worth experience with a bridgeport and a lathe combined. (but the shop teacher never let his eyes off me) Last truth would be that I dont have a huge budget surplus. Inginuity however, I have in abundance.

I have 2 concepts based around 3-5 HP b/s or tecumseh, vertical shaft engines.

1st concept involves utilizing 5 seperate and unmodified engines, mounted to a plate, using a planetary type of gear drives, where you only need to create a throttle linkage setup for fuel control, and use the gear timing to determine the firing order. this seems to be the easiest, "cheater" way of getting something feasable to run, with a basic type of a radial concept.
Here is a link to a model for sale that got me thinking...
E-bay Item number: 250223456598 (in case below link doesn't work)
http://cgi.ebay.com/Old-Original-Exp...QQcmdZViewItem

Now, obviously a few things would be different, such as the mounting plate would be rather big, basicly mounted as though on a huge mower deck, the gearing being below, using meaty gearing that could be housed almost transmission like. that would take the most engineering, but i think the right gears could be found. this would also allow for using different timing orientations for some hilarious experimentation. A great first project anyways, but probably a bit big to be any of any use.

My second, more elaborate scheme would en essence involve quartering 5 identical garden variety vertical shaft engines, welding them together making a single common housing, then re-engineering a cam type set up, a new master crank, oil sump/geared pump, pressure lube, and going on from there. Would it be easier starting from scratch, or is the there any possible way to in essence, weld 5 mower engines together to create a single, 5 cylinder monster briggs that could swing a 6 foot blade at 1800-2500 rpms, mowing an average farm in like, 10 minutes? Yea, it might need a 12 gallon gas tank to go a quarter acre, but then, the fun is in the presentation, isn't it?

Am I totally off my rocker, or does anyone here see any possibilities?

Thanks.
Radialnut