[widgitmaster]

The construction of my new Super-V router is nearly finished, and I have started working on the electronics. So far I have everything required, including a new Manual Pulse Generator. Here is a list of the main components I'll be using:

65VDC 6A power supply.
Four Gecko G202 stepper drivers.
Bob Campbell's Breakout Board Plus.
Manual Pulse Generator, model ESM80.2.100.12.R.R

Now I have wired one other router in the past, so I feel confident that I can hook this one up without too much difficulty. The problem I'm having is the lack of information as to the correct application of the Manual Pulse Generator to the breakout board.

I have contacted Bob Campbell, and he said the Manual Pulse Generator is compatible. He also said he would look for a document which explains how to add it to the breakout board. Unfortunately he has not responded. Now I'm in need of this information, so I can design the console which will have all the controls and switches for the router.

If anyone has any information as to the proper procedure and wiring, it will be greatly appreciated!

Widgit