I just got DolphinCadCam for Lathe. Therefore in the learning stage.
I'm a hobby user using Mach3Lathe software on stand alone computer to
run machine. I have Dolphin loaded on seperate laptop where I do all
drawing, etc. I've did a test drawing and got everything OK thru CAD
and CAM. My question is when I create the postprocesser (Mach3) file
how do I save it to a file so that I can copy and transfer to the other
computer? Can't seem to figure it out. Only way I have found thus far
is to select the g-code shown at the bottom of the page, copy it to
note pad and save to file. Is there a better way direct in Dolphin?

(Also posted this question on the YahooGroup.)