Quote Originally Posted by acidice333 View Post
My moshi board died on me just today.
Perhaps you need to PM Fishface (message #7) who has a spare chip.

If it was me I'd try changing the 32MHz crystal, always a good bet with a dead CPU.

Is MoshiDraw 2013 an improvement? I downloaded a copy.

I put the water pump in today and my laser now burns tiny holes in paper when I click the "Test Switch" but does that mean it is set correctly, it is a mystery.

Did you find a helpful "how to use Moshi" instructions somewhere? I seem to be looking at a drawing package. It would be nice to see the laser at least try and do something.

If You replace the processor then Moshi probably has to be consigned to the bin. I notice in "Systems options" it has IN; and PU; commands, suggesting the laser is working as an HPGL plotter, but that only helps if it comes up as a serial device.