Hi Gerry !
Hop all is fine as you'd like !?
Having a ...strang "new" kinda trouble....and, simly, well....easier to ask then spend more then I lately tried to understand !!
My situation goes as :
When I open the computer and your screen set, all is fine as fare what I'm refering to ( jogging mode)
When I open a NC file, all is still fine, set the rough position and then the tool setup...and on !!
After the completion of a NC file or even pat of a file, when it would call for a tool change....can't jog in continuous mode anymore ??!!
When I go to the jog sceen, I then see the continuous botton with the Step button on ?!? ( See photo )
Attachment 290948
Attachment 290950
Any idea what's up ??...and a solution to fix this....never seen before !?!
Thks, Robert