After lots of playing I finally have gotten my Notebook Computer to send through anything I draw in the AutoLaser Software that came with the machine. The Tube is a RECI Brand and says 100w on the Label. It is suppose to have an Autofocus but I don't know where or what I would be looking for to find this.
Problem is I set the Circle on "Cut" and gave it 100% Power and it produced a thin black circle that didn't cut into the 12mm MDF
I then tried to slow the cut down to 5mm per second and it produced a much wider line but again it didn't cut into the surface.
Thanks in Advance for any help