Re: Mach3 2010 Screen set
Originally Posted by
rwskinner
Jerry, I upgraded my Aspire and I think it messed up some stuff. I haven't dug into it yet, but I think the post processor was overwritten.
Machine Always does an initial tool change, even when to correct tool number is in during start. In other words, Tool 1 is installed, the Tool Number is #1 in Mach. I zero the tool on the plate, then it goes to the fixed plate, then wants a tool change, then does the fixed plate again, then it starts cutting. Also, No more parking when complete, goes to tool change position.
A few other small oddities. Honestly it was a while back when I set all this up and it's been going great until recently.
Any pointers so I don't spend lots of time troubleshooting?
Richard
My machine is doing the same when I click for one tool it goes to the removable plate then I click it again to start cutting it goes to the fixed plate as well.
http://www.cnczone.com/forums/diy-cnc-router-table-machines/140832-cnc-software.html