Hello Pitre,
Everything is in order now, only one problem, x is 1mm under travel, mean I have to add 1mm to achieve desired position.
Hope you can help me resolve it.
Thanks,
Ajay
Hello Pitre,
Everything is in order now, only one problem, x is 1mm under travel, mean I have to add 1mm to achieve desired position.
Hope you can help me resolve it.
Thanks,
Ajay
Hi Ajay,
Assuming your controller is 04PC ......check adjust the X axis Grid shift Parameter No. 82 ......
the value of this parameter can be positive or negative ......... ( Note the initial value ) and change as per your requirement.
**** we provide all kind of Troubleshooting & Maintenance Services for CNC Turrets , Lasers & Press Brakes. Let me know if needed......!
Get in touch on [email protected] ( 9404222266 / 8554014614 )
thanks.
Thanks Mr. Pitre,
Will check and revert in a day. BTW what is your location in India, I am at 200 KM from Delhi, in Haryana.
Thanks a lot for your help.
Regards,
Ajay
Hi Ajay,
I am based in GOA .....25 kms.....from the capital Panaji......
Thanks a lot Mr. Pitre,
The machine is working fine now, but some time we are facing a problem... the holding down clamps will not come down to hold the sheet while repositioning and alarm 2042 W Dog Timer (M10-01ExEcMF TF-EF) appears on the controller.
Can you please guide?
Thanks
Ajay
Hi,
Mr. Ajay
This is Deepak from mumbai.
I just want to know that you are talking about clamps or work holder? if you are talking about work holder then you have to check the valve or clean the cylinder.
You can call me :- +91 9222018538 / +91 8149636586
we dealing in all kind of Troubleshooting & Maintenance Services, Retrofitting, Installation for CNC TPP, Lasers, HMC, VMC, VTL Etc. Let me know if needed......!
Get in touch on [email protected] / [email protected]
Thanks & Regard's
Deepak
Hello Mr. Deepak
Thanks for your support, will get the valve clean today and let you know the outcome.
Sure, will get in touch if I need your help.
Thanks,
Ajay