150A or 75A current through that PCB those FETs, those wires and those connectors?
Really?????
Cheers
Roger
Results 1 to 20 of 141
Hybrid View
-
07-03-2016, 12:27 PM #1
Member
- Join Date
- Jun 2010
- Posts
- 4256
Re: Open source low cost servomotor controller
-
07-03-2016, 01:54 PM #2
Registered
- Join Date
- May 2016
- Posts
- 41
Re: Open source low cost servomotor controller
Yeah ;D
Originally Posted by RCaffin
This is not a continuous rating, but peak rating. The continuous rating will be significantly less than that.
But it is the peak rating that is important, as the the torque peaks only during the first bit of acceleration in a move, and the last bit of deceleration. If you are using the torque to push continuously into a workpiece, the system should be dimensioned such that you would use much less current for that.
Reply With QuoteSimilar Threads
-
Would you participate to an open-source CNC controller?
By eSilviu in forum PollsReplies: 31Last Post: 08-24-2015, 10:03 AM -
Smoothie CNC controller, Open Source.
By Rolf_K in forum Laser Engraving / Cutting Machine General TopicsReplies: 6Last Post: 01-15-2015, 07:41 PM -
CNC Controller with Arduino - open source
By Christian Knüll in forum Open Source Controller BoardsReplies: 16Last Post: 12-22-2012, 10:46 AM -
Open Source CNC Controller Specification
By gregmary in forum DIY CNC Router Table MachinesReplies: 28Last Post: 12-05-2005, 04:58 AM -
BEST Open source Controller ?
By Seventeen in forum Open Source Controller BoardsReplies: 12Last Post: 09-22-2005, 12:27 AM
Tags for this Thread
Posting Permissions
