I am new to this fusion 360 and for the last 2 days I have been trying to get g-code for a design I have made. I can generate tool paths and can get the code but when I read through the code it isn't right. There is some problem with the origin I think.
Also this is a very simple pocket I'm trying to do. All cuts are on the same plane but when I read the code the z is all over the place.
Is there anyone on here that I could send the drawings to and they send me back the code (for Mach 3)?
I will figure this program out but right now I just need this code!
Thanks!
Any help would be great!