i've tried asking them before but all they do is keep sending the same manual to me.
No only the amp settings which I never found, now if you have the main Parameter settings in place, then there will be some control things we can try, Does the VFD power up ok can you do some photos, have you opened the cabinet
What setting did you use in D031
D032
D033
Try them all at 0
Mactec54
Don't run it at that speed for very long only just to try the speed, this could damage the spindle
Do you have all the Parameters I posted these must all be in place before running
Have you switched the Spindle Mode Switch set to Manual on the front of the control Panel
Mactec54
Hi A-Camera will this help, I opened my controller box and got a pic of the vfd board and on it there is a number that says FD-A-V2 date 7/12/2016 110v AC is what system i have not 220v like most of the systems vie seen listed, which as a newbie I didn't realize I was talking to you guys in Austrailia, I'm just a yank in the US. Any chance we can find the parameter chart for this VFD?
Thanks for all your input CHIMERA1960
Note: I just bought the model 6040 Cnc with 1.5KW spindel motor 400 Hz 110v AC control box number VFD No.FD-A-V2 L.E.D. screen PRT-E1500W
P.s. number in the upper right corner of pic I just took another look not shure the "V" might be a "Y" it is also made by JD Works in China, I've sent them email to ask for help
Hello Mate you would'nt no were i could get information or pictures on the wiring for a zero touch probe for the PRT-E1500W. I can't seem to find it any were. Thank you.