Recently I bought a 6040 4 axis cnc router off of eBay and the instructions didnt have the right settings for the vfd that came with it.What should I do. I attached the manual to the thread THANKS.
Recently I bought a 6040 4 axis cnc router off of eBay and the instructions didnt have the right settings for the vfd that came with it.What should I do. I attached the manual to the thread THANKS.
koolkleptokidd
A lot have been having this same problem, you need the manual for the VFD drive then you will be able to set the VFD
Mactec54
Did you check the whole contents of the DVD? If not there you should ask the seller. If you can't get the manual from the seller you should give negative feedback and demand some refund or send it back. It is horrible that those people keep selling these products without even a crappy simple manual.
yeah, ive checked it multiple times and cant find anything, I attached the manual if you want to read it.
koolkleptokidd
This will get you started, there will be other adjustments needed, what size spindle motor do you have 800w or 1.5Kw
D000=400
D001=1 ( May be D000=0 by Default this will lock any Parameter Change )
D002=400
D003=400
D004=220
D009=400
D010=100
D011=10 ( Default=10 Adjustable Acceleration )
D012=10 ( Default=10 Adjustable Deceleration )
D031=0 ( Default=0 For Keypad use (1 ) for Remote Control )
(D031 May need to be set to 4 D031=4 Depending how your Control is being used)
D032=0 (Default May need to be set to 1 D032=1 Depending how your control is being used )
D033=0 ( For Keypad Stop ( 1 ) If Remote Control is being used )
D036=1
Mactec54
I have the 1500w spindle motor.
Mactec54
i've tried asking them before but all they do is keep sending the same manual to me.
No only the amp settings which I never found, now if you have the main Parameter settings in place, then there will be some control things we can try, Does the VFD power up ok can you do some photos, have you opened the cabinet
What setting did you use in D031
D032
D033
Try them all at 0
Mactec54
Don't run it at that speed for very long only just to try the speed, this could damage the spindle
Do you have all the Parameters I posted these must all be in place before running
Have you switched the Spindle Mode Switch set to Manual on the front of the control Panel
Mactec54
Another 2 to try just do 1 at a time and try it, it could be just one Parameter some where I will keep looking there may be something I missed, the manual I have is in Chinese and it has not translated very well
Change D036=0 to Zero also
D020=400
D040=100
Is your power supply 120v or 240v
Mactec54