[koolkleptokidd]

Don't run it at that speed for very long only just to try the speed, this could damage the spindle

Do you have all the Parameters I posted these must all be in place before running

Have you switched the Spindle Mode Switch set to Manual on the front of the control Panel

I did put all the settings in place and I changed it to manual.

[mactec54]

I did put all the settings in place and I changed it to manual.

Another 2 to try just do 1 at a time and try it, it could be just one Parameter some where I will keep looking there may be something I missed, the manual I have is in Chinese and it has not translated very well

Change D036=0 to Zero also

D020=400
D040=100

Is your power supply 120v or 240v

[koolkleptokidd]

Another 2 to try just do 1 at a time and try it, it could be just one Parameter some where I will keep looking there may be something I missed, the manual I have is in Chinese and it has not translated very well

Change D036=0 to Zero also

D020=400
D040=100

Is your power supply 120v or 240v

Its 120v

[koolkleptokidd]

Its 120v

I tried the d020 and d040 setting and it does the same thing.

[mactec54]

I tried the d020 and d040 setting and it does the same thing.

So the trim pot makes no difference when you turn it, we will try some different setting that control this D031=5

Do you have the VFD in the right mode for Running you may have to scroll to select this

[Twofinger]

Any new news on this? I have the same VFD and have entered all of the numbers listed and all I get now is flashing digits "00.0" on the VFD screen. It does not respond to manual or Mach3