[LtDan]

what size wires are you supplying the rectifier side of the drives with?

How far is the run of wire from the main source?
Mine is 60ft so from main panel to control box outlet is 8awg in the box is 12awg all depends on amp draw and voltage drop.
There are plenty of calculators online to calculate this.

[GM1G]

How far is the run of wire from the main source?
Mine is 60ft so from main panel to control box outlet is 8awg in the box is 12awg all depends on amp draw and voltage drop.
There are plenty of calculators online to calculate this.

i was gona run #10/4 about 30 feet then #12's split to the drives

[LtDan]

Add all your amperage and then use a calculator. if your using 3 750w drives and a 2hp minimum motor i would run the 8awg

[GM1G]

Add all your amperage and then use a calculator. if your using 3 750w drives and a 2hp minimum motor i would run the 8awg

this run will be just for the 3 drives and 3 750w servos

the vfd is on a separate circuit

[LtDan]

Well its been awhile, so hows your project going?

[GM1G]

Well its been awhile, so hows your project going?

after a lot of procrastination as far as buying conduit and wire

i finally did and was running and hanging it today

ive had my replacement drives and motors back from dmm for a few months now

so im working on it

[Michael82]

after a lot of procrastination as far as buying conduit and wire

i finally did and was running and hanging it today

ive had my replacement drives and motors back from dmm for a few months now

so im working on it

@ GM1G what ever happen ? There hasnt been a update in a while ..?????????