[cnctoolman]

Does anyone know the part numbers for the Thrust Bearings on the X and Y axis? Looking to replace them and would like to have them in hand before I tear into the mill.

thanks for any help

[underthetire]

Noise or backlash? If just noise, they should have a zerk fitting underneath that silences them right up with lithium grease. Can't help with numbers, never had to change even one set while working for the distributor.

Sent from my A3-A20FHD using Tapatalk

[cnctoolman]

Noise or backlash? If just noise, they should have a zerk fitting underneath that silences them right up with lithium grease. Can't help with numbers, never had to change even one set while working for the distributor.

Sent from my A3-A20FHD using Tapatalk

Alittle backlash in the "y" so figured since I was doing it, I might aswell do "X". Also chasing a small finish issue in "x" aswell. machining a side cut, go down one way, smooth, go the opposite and alittle chattery. Climb milling, same part, opposite sides.