Series 3 1100.
During second operation of the day (simple peck drill cycle) Z axis went caput. Note the burned leads at the driver from the stepper (2 of 3 leads). Driver continues to have red fault LED, even after stepper is disconnected. Likely just as toasty inside as it is at the connector.
So, my question for you folks because I had to leave and play dad. When I get back here in the morning, can I verify the stepper is okay too, without risking blowing another driver? Between the 3 leads resistance measures between .8 and 1.0 ohms.
Thanks for all help, and advice in advance.
WW