Thanks, my Intent is to setup my 4 position CNC turret for it but I do have some small parts that I think I would like to use a gang tool on but I'm not at that level to set up the gang. I'm learning quickly but also have to run a Vintage restoration shop while learning.

The cost savings was why I went with this machine. I could pay it off in less that two years if I just did the parts we need in house and nothing else. I did get the speed to 1:12 min. each when I don't talk while doing it while doing it.
I ran two hundred parts that cost me in house $1.14 each with material that would have costed $600 plus shipping sent out to a shop, so it s a no brainer for me. The finish is just as good and it ran 0.001 - 0.0015 consistently. I need 0.004 on these parts