[charlie1126]

The spindle info is below. The power to the drive is 36V 13.8Amps. I put the dip switches to the max amperage on the drives.

Frequency:	400 Hz	MPN:	UNBSU007
Speed:	8000-24000 R/min	Model:	1.5KW
Runout off:	less than 0.005mm	Country/Region of Manufacture:	China
Input Voltage:	220±15%	Inpute Voltage:	220V
Output Voltage:	-208-240VAC	Outpute Frequency:	0-400 Hz
Input Frequency:	48-63 Hz	Diameter:	65mm x Length:188mm
Output Frequency:	0-400 Hz	Power:	1.5 KW
Output Phase:	3 phase	Voltage:	220V~250V
UPC:	283961317893	EAN:	0283961317893

[skrubol]

Ok. I just used meshcam to convert the gcode and for like a minute it looked like it was doing everything right. Then it had a mind of its own. X and y motors were really hot. Not sure if that's normal. Maybe the drivers

The spindle info is below. The power to the drive is 36V 13.8Amps. I put the dip switches to the max amperage on the drives.

You might be running the motors too hard. Try backing off on the current a bit. Too much current will overheat the motors and reduce their power as well. Do you have specs for the steppers? What is the max current for the TB6600?

[charlie1126]

forgot pic and code.