[shas595]

That is a keep relay - so you have to go to Keep Relay 00 and change bit 3 from a 0 to a 1. PM me if you need more help and I can send you a procedure on how to fix this

John

[juancastro]

That is a keep relay - so you have to go to Keep Relay 00 and change bit 3 from a 0 to a 1. PM me if you need more help and I can send you a procedure on how to fix this

John

Can you send me the procedure please?

[email protected]

Thank you!

[shas595]

Sent - take a look and let me know how it works out

John

[greelyman]

Hi John, It looks like you have a lot of knowledge of Hitachi-Seiki's. I have an HT23J. The tool unclamp/clamp piston hit the hydraulic tool release piston while the turret was indexing, & stopped the turret. I don’t know how to get it back to zero. Can you help me with the procedure to zero it?
Its a Hitachi-Seiki HT23J with a Yasnak control.

Thank you

Mike

[tomgaasenbeek]

Hi John,

I am working on a Hitachi HT40G Lathe with an older Yasnac LX-3 control. The 10-position turret just spins when commanded, and we have already checked the wiring and even changed the encoder (a Sumtac). We are beginning to suspect that a Hitachi reset procedure is needed - like one would have with a dogless home. Do you have any advice on this turret issue? My e-mail is [email protected] - thanks...

Cheers, Tom Gaasenbeek

[jiugongzi]

That is a keep relay - so you have to go to Keep Relay 00 and change bit 3 from a 0 to a 1. PM me if you need more help and I can send you a procedure on how to fix this

John

Can you send me the procedure please?
[email protected]
Thank you!