Hello,
I am using Heidenhain iTNC 530 and have following code programmed:
...
T10 G17 S5475*G54 G90 X+0 Y+93 Z+0*
PLANE SPATIAL SPA-90 SPB+0 SPC+0 TURN F40000 SEQ-*
G00 G40 G90 X-136.5 Y-38.5 M3 M7*
Z+5*
G200 DRILLING
Q200=+5 ;SET-UP CLEARENCE
Q201=-45 ;DEPTH
Q206=+100 ;FEED RATE FOR PLUNGING
Q202=+45 ;PLUNGING DEPTH
Q210=+0 ;DWELL TIME AT TOP
Q203=+0 ;SURFACE COORDINATE
Q204=+5 ;2ND SET-UP CLEARANCE
Q211=+0* ;DWELL TIME AT DEPTH
X-136.5 Y-38.5 G79*
....
I am simulating the machine in PC and the simulation runs without any problems.
The problem is, that for some reason, the real machine (which I do not have access to) stops without any alarm at the bottom of currently drilled hole (at the last line of attached code) and does not retract.
Does anybody know what setting can be responsible for this stop?
Thank you