[Erik D_lux]

Looking for approx 100pcs made from 4140ph.

+/- .002 on all measurements.

Everything should be in the PDF with the exception of the slot on the back side. Both sides need the exact same slot. Also, there are 4 M2 tapped holes that should be in there but I am not sure the PDF shows that?

I would prefer if I could have these within 4 weeks. I had somebody else working on them for quite some time and they said they would ship on the 26th of Jan and I have never heard back from them.

I also have a bunch of mill work parts that I need on a regular basis. Since this last guy dropped off the face of the Earth, it would be nice to find a reliable mill guy.

Please email [email protected] No PM's please

[Erik D_lux]

drawings if the PDF does not pull up any dimensions.

[Erik D_lux]

I think I frustrated everybody with the napkin drawings so I tried to make some better ones. Hopefully it helps.

[cooperjm]

Did you receive my quote? It was emailed a few days ago.

Sent from my SM-G955U using Tapatalk

[Erik D_lux]

Did you receive my quote? It was emailed a few days ago.

Sent from my SM-G955U using Tapatalk

I dont think so? I dont really know who you are though...

[Erik D_lux]

Job has been awarded. Thanks a lot to everybody who took the time to quote this job!