Check your block data to see if any M-codes are flashing. Check in position window of c-axis or RDIFF in axis page for C-axis.
Those should point to where the issue is.
Best regards,
Results 1 to 14 of 14
Hybrid View
-
03-25-2018, 05:38 PM #1
Registered
- Join Date
- Apr 2009
- Posts
- 1262
Re: C-axis will not clamp. Okuma LB300
Experience is what you get just after you needed it.
Reply With QuoteSimilar Threads
-
Okuma LB300///OSP U100L
By iffe123 in forum OkumaReplies: 4Last Post: 08-25-2023, 04:30 PM -
Okuma LB300 Parts Manual
By TonyW in forum OkumaReplies: 9Last Post: 08-02-2021, 04:26 PM -
Okuma LB300-M. X axis servo vibrates whit peaks at every 3 mm increment, any idea?
By deepforrest in forum OkumaReplies: 14Last Post: 11-21-2016, 10:08 AM -
Okuma OSP U100L serial on a LB300
By fomaz in forum OkumaReplies: 2Last Post: 04-24-2013, 06:59 AM -
Looking for Okuma LB300-W Lathe Specs
By TonyW in forum OkumaReplies: 6Last Post: 02-28-2011, 09:43 PM
Tags for this Thread
Posting Permissions
