Running 110v single phase.its just a 2hp porta cable router
Running 110v single phase.its just a 2hp porta cable router
120v if you live in NA
Why are you using the Relay Board the solid state Relay if 5v to 30v input can be switched direct from the Breakout Board
Are you getting and output from the Breakout Board 0-5v check this with a meter this is what has to be working before you can check anything else
Mactec54
Yes I'm getting 5v and I was only gonna use the relay board but in the instructions it said to also use a solid state relay so that's why I'm using a solid state with the relay board....
Then that should be enough to switch the Solid State Relay by it's self, can you do a close up of the top of the SSR this will tell us the operating voltage and amperage most have an input of 4-32v Dc
Yes the relay board could not switch the spindle by itself but may not be needed at all if you have the correct Solid State Relay which is a better way to do it
Mactec54