I NEED HELP.
im going from 3d printing to CNC Machining and i've never seen a cnc machine before.so im a NOOB.
currently i have mach4 installed and communicating with ESSMB3. and i can send commands via mach4 for spindle start and i get 0-10v on AG-AO pins.And I have MB3 PROFILE LOADED TO it.i did not program new profile. when i start spindle relay Y101 turns red but i dont know where to plug this into VFD. And if i go into PINS CONFIG i can see SPINDLE, NO3 Relay3 but i dont understand where the wire goes to vfd.
and my main problem is determining where the wires go for the spindle and getting it to work properly.
1. So my spindle is 3phase and i have this wired to breaker box,to vfd, and to motor and there is a electric break device connected to vfd. this part is done.
1)But spindle is water cooled and has a 24v temp sensor in it. i was going to purchase a water chiller for this spindle and was wondering if it connects to the chiller or ESSMB3 or managed by another device.
2)Spindle also needs oil
https://www.neobits.com/kbc_tools_1_...6.html?atc=gbs
and i would need to connect this as well
3)Spindle also has a ATC and another airport for blast of air threw spindle to blow off debris that might be on toolholder. and i purchased a 2 Position 5 Way 6 Pneumatic Solenoid Valve w Base to control all this stuff.
4)I was going to get a fog buster as well.
Attachment 2 is the manual for vfd
HONESTLY
I think i went a little overboard with this project but i really need a cnc. HAAS turned me down so i got a idea and jumped in. i changed a control board on a 3d printer and it took 2 months to figure that mess out. and this is way more involved and the build still has a long way to go. So any help would be appreciated. And if anyone wants to mentor me for this project i would very much appreciate it. and we could work something out for compensation.
thanks for any and all help!