Yes design like this was also on my list but with that design i loose some vertical z axis machining space. For now I will stick with side ATC like in post before.
So little update, my electronic components are over customs and are waiting for transport from my nearest port to my house.
Also I did get quotes for Nanodur Compound 5941 - 480€/ton
That is not to bad and i need exactly 1pallet /1ton of material for my machine
I need to organize transport and then I order this material also.
One photo for easier imagination of the machine size (man in CAD is 185cm tall)
I will need to make some additional legs for machine as this working table height is too low for ergonomic working environment
- should machine like that even have legs or should be just fixed in place, bolted down or cast in place ?
I still have 25cm of room to play with after that i'm too high with z axis :/