[dongZ]

Alright so according to the procedure, I was really close. The switch it's referring to is a hardware deceleration switch. The axes cannot be on that switch when/if you attempt to home an axis out.

Try holding P + cancel when powering the machine on. Keep holding those two buttons and try moving any axis in the "-" direction. If it allows you to move the axis, it's possible your pulse coder lost it's brain and didn't know where it was.

Also, what in the world did you film that video on it's so hard to see what's going on lol sorry

I just tried holding P+cancel while power up and continue holding them, and i still cannot select axis, X1 X2,Z1 Z2, those lights are still flashing. Thank you.