[andresantosgodinho]

OK Philip,

if you are sure about this datas please
reply it on Monday, also I need the Controller Type
810 GA1 or GA2 or GA3
also I need a Email Adress where I can send the Datas

regards
Thomas

Hi Thomas,

I know this is an old topic but I have recently purchased a used Chiron FZ 12 S High Speed with a Siemens Sinumerik 810M GA3 controller.
Unfortunatly the machine was disconected for a long time and all parameters were lost.
I have all documents with the original parameters signed in april of 1995 by someone who's name is Buschle.
I have followed the instructions to write these parameters into the 810 but i have not been able to get the machine to turn on.
I would like to know if you can provide the original parameters or a backup copy of them of something that will make the machine run. I might be missing something.
Machine type is FZ12-S 20W
Machine Serial Number is 474-13
NC-Optionen Standard:
B70,B75,N02,E31,F72,B61,F05,E42,N31,N32
NC-Optionen kostenpflichtig:
A04

Thank you in advance,
André Godinho