HELLO EVERYBODY
For your questions and solutions, please write here
thanks
HELLO EVERYBODY
For your questions and solutions, please write here
thanks
Hi I have an okuma mc4va osp5000
I get 109A spindle drive unit problem very day for 5 times every time I have to resrt the drive unit to clear the OC , OL alarm could you help me please Thanks
Hi. I have an OKUMA LCC15 on the OSP500L-G, built in 1995. When turned on, 13 CPU-ALARM INTERRUPT ERROR appears on the screen. I ask for help in troubleshooting this problem.
Last edited by iAbarth; 01-19-2024 at 01:04 PM.
13 CPU-ALARM INTERRUPT ERROR
D0=001E845D D1=00000000 D2=00000000 D3=00000000
D4=00001FFF D5=FFFF0000 D6=00001FFF D7=0000FFFF
A0=00000000 A1=00000000 A2=00000000 A3=00000000
A4=00200000 A5=00000000 A6=00000000 A7=000004F6
US=00000000 SR=00002404 PC=0FB02C6C
I have an Okuma mcm-b bridge mill with an OSP 700m control. I am getting a 923-11 alarm P SVP sa communication error MAaxis 2. We replaced the tool changer servo and the fiber optic cables which were damaged but we are still giving the alarm it looks like we need a new SVP board or the control PCB if you have any good suggestions or help I would greatly appreciate it and it sound for almost 2 weeks we've paid two different technicians over 20 hours of pay to come in here and not get anywhere
Yes I did. I believe the svp board related to the servo drive we replaced was also bad. I switched it with one of the others and the alarm followed it to the same board and card #6. We ordered a new one it should be here tomorrow and hopefully our problem will be solved
So it was a drive? I am having the same code pop up. We trying to figure it out now.
We had to replace the drive and the SVP board associated with that drive. That got rid of our alarms but now we are getting a memory error and I'm trying to figure out if we need to reload the floppy disks